Would you like to know more about our course ‘Design for Additive Manufacturing’ and are you or is your company a member of the DSPE? Attend DSPE’s knowledge session on the 28th of September at Fontys’ ObjexLab. Check out our lecturers ‘in action’.
Objexlab is the fully equipped 3D printlab. It focuses on the latest developments in Additive Manufacturing (3D printing). This technique offers many new possibilities in comparison with conventional (machining and not machining) production technology.
Most designers and constructors are trained from the traditional production technology, leaving these new possibilities often unexploited.
Knowledge session 28 September 2017
On this DSPE Knowledge day we will look at the typical characteristics and possibilities of 3D printing for machine construction and its influence on the design of machine parts. These include the design and realization of monolithic structures (including setting mechanisms), mass reduction (application of ‘lattices’) and hybrid production technology (combination of conventional production technology with 3D printing).
PROGRAM 28 SEPTEMBER 2017
13.30 Registration and coffee
14.00 Opening by Adrian Rankers, Board Member DSPE. Introduction by Sjef van Gastel, director Innovative Production Technologies, Fontys School of Engineering.
14.30 Design Paradigm Rein van der Mast, revelator AM Design Paradigm, Fontys School of Engineering
15.00 Getting started
15.45 Break
16.00 3D Printing: stop prototyping, start producing! Jan Eite Bullema, Senior Scientist, TNO
16.30 Materialise, the additive manufacturing one-stop-shop Bart Vanderbeke, Senior Project Manager Materialise
17.00 Drinks
LOCATION
Objexlab Fontys, Rachelsmolen 1 (Building R1, 0.196), 5612 MA Eindhoven
Maximum guests: 20
REGISTRATION
is required. Register here.
